SENSOpipe – Flow Rate Monitoring in Pipes

The measuring system SENSOpipe is used for the monitoring of flow rate in fully filled pipes. For this, the average flow velocity in the pipe is measured. SENSOpipe modules are equipped with GPRS/GSM or XBee data transmission technique. Power supply could be self-sustaining.

To request more information and prices call + 49 351 88646-00 or e-mail us: info@uit-gmbh.de.

  • Measuring range for flow velocity intervals from 0.02 - 2.5 m/s to 0.02 - 10 m/s – setup by manufacturer
  • Minimum electric conductivity of fluid: 10 μS/cm
  • Deduction of flow rate from measured average flow velocity at given pipe diameter

Advantages

  • Cost-efficient measurement of flow rate, applicable up to large pipe diameters
  • Retrofit in existing pipelines possible
  • Integrated data logger and data transmission technique
  • Alarm functionality
Liquid Consuctivity Required minimal conductivity of water 10 μS/cm
Pipe cross section to use in fully filled pipes
  Pipe-Flow Sensor
Measuring principle Magnetic-inductive, in pipe installation – one installation point for velocity measurement and calculation of flow rate
Measuring range Adjustable: min. 0.02 – 2.5 m/s, max. 0.02 - 10 m/s
Accuracy Accuracy ± 1% of measured velocity value or ± 0.03 m/s under reference conditions measured in proximity of sensor (the respectively bigger value applies)
  Data logger with telemetry, power supply incl. signal amplifier for pipe flow sensor
Input 3 x 0-20 mA, 3 x 0-5 VDC
Resolution 16 bit
Counter inputs
2 counter inputs
Interfaces MODBUS, RS 485 RS 232 for additional sensor, e.g. camera
Data transmission time
Adjustable, independent of sampling interval
Memory data
512 MB storage for data, approx. 1.000.000 recorded files
Memory pictures
512 MB storage for pictures
Wireless data transfer
Type 1 or Type 2 alternatively
  Type 1: Integrated GPRS/GSM modem, 4 band GSM/ GPRS Selectable data transmission modes: GPRS-FTP, GPRS-http; GSM
 
Type 2: XBee short distance communication, 868 MHz, sel-ectable power 1 mW, 25 mW, 100 mW, 200 mW or 300 mW
Interface
USB 2.0 for read out of data’s and parameterization
 
Optional: Integrated WEB-Server to provide a WLAN access point. Browser-based communication by Smart-Phones, Tablets, etc. for display of actual values and basic parametrization of data logger without installation of software
Parameterization PC software SENSOlog
Standard antenna
Roof antenna, 2 dB
SMS alarm notification
Two channels to select, up to 6 alarms, max. 5 short messages for each alarm (Typ 1)
Power supply
Integrated accumulator 12V/ 10 Ah, DC/DC converter 12VDC/ 24 VDC and solar panel 10 Wp
 
Alternatively 220VAC
Housing
Aluminum injection molding, IP 65

Illustrations and descriptions may vary. The plant / product is subject to change depending on technical updates.

We will gladly give you an individual offer.

Weld-on nozzle for mounting of the sensor in steel pipes.

 

Anfrageformular



16.05.2017